Hi Tre,• Open the ASMT Advance Steel Management Tools• Go to Settings>Defaults• Select Use filter and type Incorrect in the filter field• Select Drawing –Dimensioning and highlight General• Uncheck Erase incorrect manual dimensions on update• Select the icon to the top far right “Load settings in Advance”Go back to your model and select Update Defaults from the Manage tab.Open your Drafting settings:• Select the Objects Snaps tab and disable all your object snaps except the Endpoint, midpoint and Node.• Clear all the objects Snaps on the 3D Object Snap panel.• Select Preferred for Manual Dimensions on the Steel Osnap tab.NOTE: You can insert or remove dimension points to or from a chain of dimentions using the Insert point tool on the Labels & Dimensions tab on the Parametric Dimensions panel.Save and close the drawing then repeat Updates and the dimensions should stick.See attachment below for a step by step.I hope this helps.Best regards,Janet
Attachment: DIMENSION-How to rectify moving dimensions after update.pdf