Hello Greg,
There is no automatic tool, but you can use the following workarounds:
- for square & rectanguler tubes: create a "Polygonal contour" on one of the beam edge ; then use the Advance Steel copy command to copy this contour (= cut) e.g. by mirror on the other edges of your beam (see attached picture)
- for round tubes (pipes) : create a "Polygonal contour" on one of the beam edge ; then use the "Advanced copy" command to copy this contour (= cut) with a "Polar array" all around your circular tube.
Regards
Philippe
Attachment: Bevel cut all around a HSS beam.jpg