-
Unknown Single Part Prefixes - please help
What do the following abbreviation stand for:
1) "SoROR" (presumably a pipe section)
2) "FL" (what is the different between "FL" and "PLT" which stands for plate.)
Thanks
Attachment: [file not found]
-
"Drawing-Cannot-Be-Saved" Message Popped Up While Modelling In AS2014
Error message: “One or more objects in this drawing cannot be saved to the specified format. The operation was not completed and no file was created” pops up during modelling and attempt to save the file. To continue working on the model, closing and re-opening AS is necessary. However, some data will be lost. Please help. Thanks
Attachment: Drawing-Cannot-Be-Saved Message Popped Up While Modelling_2.png
-
Incorrect Weight Of Single Parts On BOM (plates)
· Part mark: BB-13 (see attachment)
· Manual weight calculation (opening considered): 115.3 kg
· Manual weight calculation (opening not considered): 138 kg
· Advance Steel calculation: 203.92 kg (in excess of 65 kg)
-
How to draw a roundbar with chamfer at one end?
-
How to bring back missing end post & rotate bolts
1) End post just vanished.
2) the two connecting bolts for the handrail have to be rotated to clear stiffener plates.
Acad dwg will be sent by email separately.
Thanks
Attachment: [file not found]
-
Copy & mirror command doesn't work the way it should be
1) Kicker board not mirrored
2) Channel should not have been mirrored.
Acad dwg will be sent by email separately.
Thanks
Attachment: [file not found]
-
How to set corner radius for both ends of handrail without having connector plate flying up on one side.
Thanks for your help Philippe.
We'd made several attempts but failed. We'd be grateful if you could help bring the handrail connector plate down keeping the knee (or corner radius). Dwg file attached. Strange that it only happen at one end of the handrail.
Thanks
Attachment: [file not found]
-
How to switch off connection box? Sketch attached.
How to switch off connection box? Sketch attached.Attachment: [file not found]
-
How to set corner radius for both ends of handrail without having connector plate flying up on one side.
How to set corner radius for both ends of handrail without having connector plate flying up on one side.Attachment: [file not found]
-
Is it normal to have weld symbols floating in space in my model?
Is it normal to have weld symbols floating in space in my model?
When the symbols (cluster of pluses) are double-clicked, the weld parameter dialogue box opens. Sketch attached.Attachment: weld.png