-
RE: Wie entferne ich automatisch erstellte Gehrungen, nachdem der Anschluss nicht mehr existiert?
Hallo,
selektiere die beiden Profile deren Gehrung du wieder löschen willst.
In der angefügten Datei habe ich dir einen Screenshot von der Advance Werkzeugpalette gemacht.
Die umkreisten Buttons ändern die Darstellung der Profile.
Für die Gehrung entsteht ein grüner Rahmen. Wird dieser gelöscht, wird auch die Gehrung der Profile entfernt.
Ich hoffe ich konnte es dir verständlich erklären.
MfG -
RE: Geteilt Langloch in DXF Datei
Hallo Edin,
geh mal in Managmenttools und suche nach 'Langlöcher als' ;)
Da müsste bei dir ein Haken drin sein.
MFG Basti -
3D-Bereich / Ansicht umschalten
Hallo liebe Community,
meine Frage wäre, wenn ich im 3D-Bereich mit dem visuellen Stil "2D-Drahtkörper" arbeite und dann schnell dass Modell über "Shift+Mausrad" drehen möchte, dauert das immer so lange, da er auf den Stil "Drahtkörper" umschaltet.
Wo kann ich das einstellen, dass er im Stil "2D-Drahtkörper" bleibt und nicht auf Drahtkörper umschaltet?
Danke schon mal :)
MFG Basti