-
Bevel weld missing
Dumitru,
If the weld is created by joint properties, when you right click on weld & go to "Advance Properties" weld type id dimmed (gray) & can not be changed. Any other solution?
Best regards,
Greg Daneshvar
-
Piece marks are not in order in BOM
Dumitru,
Here is attached file. Thanks for reply & help.
Regards,
Greg Daneshvar
-
Fema 350 & Graitec
When Graitec will adopt FEMA 350 moment connectionrequirements?
I would like to see the following improvements:
1-Top & bottom flanges to be cut for RBS (reduce Beam Section) values .
2-New value from face of column to face of beam web.
3-Beam web to receive miter cut for C.J.P. weld.
4-Shear tab is no longer rectangular. it is tapered. 1" horizontal,1" vertical
5-Continuity plates need gap from inner side of column flanges & be beveledalong column flange.
6-Additional fillet weld added to top flange C.J.P.
See City of Los Angeles Building Department standard details & refer toFEMA 350 publication.
Regards,
Greg Daneshvar -
All Thread on base plate & end plates.
When detailing base plate or end plate I like to see all thread option to use. On end plate to have an option to weld it to end plate too.
Regards,
Greg Daneshvar
-
Level symbol on beam shop drawings.
Where & how we can set parameters to automatically insert level symbol on ALL beam shop drawings & on columns where beam is framed to that particular column. I'm attaching a sample drawings which were done by other 3D program to show the top of beam relation to column as an example.
Regards,
Greg
-
Bevel weld missing
Bevel weld is missing on Moment connection, Shear plate dialog boxes. How we can have this weld option on all connection variables?
I needed to weld column stiffener to flange using C.J.P. option.
-
Piece marks are not in order in BOM
When moving a member from a sheet to other using either Drawing Management Tool or AutoCAD cut/paste option upon updating list "BOM" I notice the member piece marks are not in alphabetical order. Pleas see attache drawing & look at 29A member which is at the very bottom of list where it supposed to be at top.
Regards,
Greg
-
WT connection
I have not heard any reply from Graitec so far. Hope they are working on it.
Regards,
Greg Daneshvar
-
WT connection
As Daniel Miller point it out I like to use WT shape instead of shear tab. Another words we should have an additional icon for WT connection in Joint tool bar. Later on today I will send a snap shot of this connection which I applied manually to Dumitru Berteanu.
I wish we would have "File Attachment" option so everyone could view the drawings attached.
Regards,
Greg Daneshvar
-
WT connection
It is common these days to use a piece of WT for beam to column connection but I don't see this option in Advance steel. Is there a way to apply without deleting intelligent connection & adding manually?
This type of connection should be used to beam ends too.
Thanks for reply.
Regards,
Greg Daneshvar